NXR-810K2
NEXEDGE UHF Digital Conventional/Analogue Repeater/Base Station (Non-EU Use)
Find your nearest Approved Kenwood Centre
Where to Buy
| Tweet | |
Key Features
| NXDN Digital Air Interface | 
| AMBE+2 Vocoder for Natural Sounding Digital Voice | 
| Operates in NXDN Digital Conventional and FM Analogue Modes, even on the same channel | 
| Autosenses Received Mode (Digital or Analogue) | 
| 30 Channel Scanning Base Station (Conventional Mode) | 
| Digital - Single-Site Trunking (future upgrade) | 
| Multi-Site IP Network Mode (via KTI-3 option) | 
Supplied With
| Cushion | Yes | 
| D.C. Cable | Yes | 
| Fuse | Yes, 15A | 
| Handle | Yes | 
| Instruction Manual | Yes, English, Spanish & French | 
| Screw Set | Yes | 
Base Station & Repeater Features
| 16 CTCSS/DCS Repeater Controller Built-In | Yes | 
| 19" Rack Mount Design | Yes | 
| Audio Distortion | Less Than 2.5% | 
| "Base Station" or "Repeater" Mode Operation | Yes | 
| Base Station Features | Yes | 
| CW ID | Yes | 
| DTMF AUX Input Monitoring | Yes | 
| DTMF AUX Output Control | Yes | 
| DTMF Front Panel PF-Key Control | Yes | 
| EIA Voter Tone Generation | Yes | 
| External FM Controller Interface | Yes | 
| External LTR Controller Interface | Yes | 
| External MPT Controller Interface | Yes | 
| Flash ROM for Future Upgrades | Yes | 
| Front Mounted Speaker | Yes | 
| Full-Duplex Operation | Yes | 
| Hang Timer | Yes | 
| LED Display & Indicators | Yes | 
| Microphone Jack on Front Panel | Yes | 
| Program/Modem Interface | Yes | 
| Programmable AUX I/Os | Yes | 
| Programmable Function Keys | 6 | 
| Remote Termination Interface | Yes | 
| Repeater Features | Yes | 
| Time-Out Timer | Yes | 
| Volume Control on Front Panel | Yes | 
| Windows Programming and Tuning Software | Yes | 
NEXEDGE Features
| FM Analogue Conventional Included | Yes | 
| LTR Analogue Conventional Included | Yes | 
| NXDN Conventional Included | Yes | 
NEXEDGE Base+Repeater Features
| 16 RAN Repeater Controller Built-In - Conventional Mode | Yes | 
| Conventional IP Interface | Yes, From V2.00 Firmware | 
| GIDs Per Site | 1000 in Conventional Mode | 
| Individual & Group Selcall - Conventional Mode | Yes | 
| Mixed FM/Digital Operation - Conventional Mode | Yes | 
| NXDN Scrambler built-In | Yes | 
| Over-the-Air NXR Alias - Digital Conventional Mode | Yes | 
| UIDs Per Site | 1000 in Conventional Mode | 
Applicable Standards
| FCC | Yes, Part 15/90 | 
| Measurement - EIA Standards | Yes | 
Technical Specifications
| Frequency Range | 400 - 470 MHz | 
| Number of Channels | 30 | 
| Channel Frequency Spread | 70 MHz | 
| Channel Spacing | Analogue : 25 kHz/12.5 kHz | 
| Channel Spacing - Digital - Wide/Narrow | 12.5 kHz/6.25 kHz | 
| Antenna Impedance - 50 Ohm | Yes | 
| Antenna Connector | RX: BNC TX: N | 
| Duty Cycle | 100% at 25 Watts, 50% at maximum power | 
| Frequency Stability | ± 0.5 ppm (-30 °C to + 60 °C) | 
| Operating Temperature Range | -30 °C to + 60 °C | 
| Operating Voltage | 13.6 V DC (10.8 ~ 15.6 V DC) | 
| PLL Channel Steps | 3.125kHz/5.0 kHz | 
| Dimensions | 483 x 88 x 340 mm - Projections not included - | 
| Weight (net) | 9.7 kg | 
Receiver Specifications
| Adjacent Channel Selectivity | Analogue: 80 dB at 25 kHz 74 dB at 12.5 kHz | 
| Audio Output | 4 Watts with less than 5% distortion | 
| Intermodulation | Analogue: 80 dB | 
| Sensitivity | Digital: 3% BER: 0.28 µV at 12.5 kHz 0.22 µV at 6.25 kHz | 
| Sensitivity - EIA 12 dB SINAD | 0.28 µV | 
| Spurious Reponse Rejection (Analogue) | 90 dB | 
Transmitter Specifications
| RF Power Output | 25 W - 40 W | 
| FM Hum & Noise | Analogue: 50 dB at 12.5 kHz, 55 dB at 25 kHz | 
| Modulation Distortion | Less than 1% | 
| Spurious & Harmonics | 80 dB | 




 
							